Munters IceDry 30, Оригинальное руководство пользователя

Страница: 26 / 40

IceDry 30
6.4.3 Window 3, Motor status
This provides a simple way to check the status (on/off) of the motors for the process and reactivation fans as
well as the drive motor (Off = +000, On = +001).
Figure 6.5 Window 3
PROCESS FAN Process fan
REACT. FAN Reactivation fan
DRIVE MOTOR Drive motor
6.4.4 Window 4, Reactivation power
This shows the percentage of the total reactivation heater output being used at the time of the reading.
Figure 6.6 Window 4
HEATER Reactivation output being used.
6.4.5 Window 5, Alarm
This indicates all alarms. The alarms are denoted by a number, which represents a specific function alarm.
For a description of the corrective action for each alarm, see
8, Fault tracing .
If an alarm is activated, the red lamp on the control panel lights up. The alarm indication disappears
automatically when its cause is removed.
The dehumidifier always stops when an alarm is activated. The dehumidifier is equipped with the following
alarms:
1. Temperature too high, reactivation heater
2. Reactivation fan
3. Process air fan
4. Rotor drive motor
5. Reactivation heater
6. -
7. -
8. Temperature too high, reactivation fan heater
21
Control system
190TEN-1049-H1307