© Munters AB, 2015
130
13.7
Work Room Control
This screen enables controlling the temperature in the work room.
1. In
Control > Work Room
, set the following on/off parameters:
o
Heater 1 and 2 temperature
o
Fan 1 temperature
o
Fan 2 temperature
2. In
Install > Temperature Definition
, define 1 or 2 sensors as Work Room temperature sensors
(refer to Temperature Definition, page 110 for details on this function)
13.8
Scale Arm
During feed distribution, each silo has a mechanical arm that disconnects at the end of a feed cycle,
preventing further distribution. When this disconnect happens, a signal is sent from the arm to the silo,
informing the latter that it must be refilled. Farm Premium enables recording these signals in the Events
History.
To define the Scale Arm:
1.Go to Install > Digital Sensors.
2. Define one sensor as Scale Arm.
•
In History > Table of Events, Feed Delivered appears when the mechanical arm disconnects.
WORK ROOM CONTROL
Function
On
Off
Heater 1 (Temp)
Heater 2 (Temp)
Fan 1 (Temp)
Fan 2 (Temp)
16.7
16.7
21.1
21.1
18.9
18.9
18.9
18.9
TEMPERATURE DEFINITION
Function
Temp. Sensor
1 2 3 4 5 6 7 8 9
Full House
√√√▪ ▪ ▪ ▪ ▪
Tunnel setting ▪ ▪ ▪ ▪ ▪ ▪ ▪
Attic
▪ ▪ ▪ √ ▪ ▪ ▪
Outside
▪ ▪ ▪ ▪ √ ▪ ▪
Egg Room
▪ ▪ ▪ ▪ √ ▪ ▪
Work Room
▪ ▪ ▪ ▪ √ ▪ ▪
Feed Area
▪ ▪ ▪ ▪ √ ▪ ▪
DIGITAL SENSORS
In
Function
Num
1
Scale Arm
1
2
< None >
0
3
< None >
0
4
< None >
1
5
< None >
0
6
< None >
0
7
< None >
0
8
< None >
0
