mundoclima AEROTHERM BBC 200, Инструкция по установке и эксплуатации

Страница: 83 / 176

27
8 - ELECTRICAL CONNECTIONS
Please choose the power cord according to above table, and it should comply with local electric standard.
The power cord type, recommanded power cord mode is H05RN-F.
When wiring the power supply, please add additional insulation sheath at the place without rubber insulation layer.
8.3 - PCB I/O PORTS DESCRIPTION
MIin. Diameter of Power Supply Cord (mm
2
) 4
Earth Cord (mm
2
) 4
Manual Switch (A) Capacity/Fuse (A) 40/30
Creepage Breaker 30 mA ≤ 0,1 sec
CN1 Power supply CN17 Electronic expansion valve CN19 T5U: upper tank water temp. sensor
CN9 Fan SW1 Factory setting for Disinfect &Electric Heater
model selection CN20 T5L: lower tank water temp. sensor
COMP Compressor CN11 On/off CN40 Display output
E-HEAT Electric heater SW2 Factory setting for 200/300 model & Power
frequency 50/60Hz selection CN27 Panel disply power supply
S.V. Saftey valve CN5 High pressure switch CN28 Transformer output
CN29 Crankcase heather CN16 Tp: compressor discharge temp. sensor CN26 Solar input
CN4 4-way valve CN18 Th: compressor suction temp. sensor CN6 Transformer input
CN2 Solar pump CN24 T4: ambient temp. Sensor (White)
CN7 Alarm CN24 T3: evaporator output temp.sensor (Black)
All electrical operations should be performed by trained personnel having the necessary require-
ments by the regulations in force and being informed about the risks relevant to these activities.
The unit must be installed with an Creepage Breaker near the power supply and must be effectively earthed.
A creepage breaker must be installed adjacent to the power supply
Never use the wire and fuse with wrong rated current, otherwise unit may break down and cause fire furthermore.
This unit is required reliable earthing
before usage, otherwise might cause
death or injury.