Multiva Cerex 300 SeedPilot, Руководство по эксплуатации и обслуживанию

Страница: 58 / 165

2917
Figure. 5.3.4. - 49. Lengthwise level
The machine is level when the sidebar (1) of the machine is horizontal.
Figure. 5.3.4. - 50. Cylinder adjustment slats
1. Turn slats (2) over the cylinder (1) shaft.
2. Carefully run the cylinder against the slats and check visually that the machine is straight.
If needed, extend the cylinder and add or remove slats, if needed, until the
machine is straight.
5.3.5. Ensuring the steerability of the tractor
The calculation of the stability of the tractor - seed and fertiliser drill combination is provided in
the attachment Calculating the stability of the tractor - seed and fertiliser drill combination. The
steering response of a small tractor may be compromised when it pulls the seed and fertiliser
drill, because some of the weight of the seed and fertiliser drill rests on the tractor's rear axle. If
steering response is weak, we recommend the use of front weights on the tractor. The tractor's
weight transfer system should also be switched off, since when using the weight control system,
the height of the lifting device may change based on the load and impact the seeding depth.
Operation and maintenance
manual
Cerex 300
1.00
57 (156)