Multiva Cerex 300 SeedPilot, Руководство по эксплуатации и обслуживанию

Страница: 143 / 165

3031
2. Lower the coulters to the ground and support the coulter to be dismounted (1) to its
place.
DANGER
The coulter weights more than 40 kg and has sharp edges.
3. Loosen the four fastening bolts (4) of the coulter.
Do not remove the bolt right away but loosen all four bolts equally.
4. Remove the bolts, installation plate (2) and the four dampening rubbers (3).
5. Move the coulter from its location.
7.9.1.2. Installing a coulter
1. Move the coulter to its location.
DANGER
Use a lifting aid to move the coulter. The coulter weights more than 40 kg and has
sharp edges.
Figure. 7.9.1.2. - 179. Fastening the coulter
2. Set the lowest dampening rubber (3) in its place and lift the coulter against the mounting
beam.
3. Install the remaining three dampening rubbers (5).
4. Install the two mounting plates (2).
5. Install the four fastening bolts and nuts (4) and tighten the bolts evenly to eliminate any
gap between the mounting plates.
Use new locknuts to fasten.
Operation and maintenance
manual
1.00 Cerex 300
142 (156)