COMMON MESSAGES
16
Wireless Acceleration Sensor User Guide
Bit 7:6
Bits 5:0
00
Sampling period defined in increments of 250ms (0.25-15 seconds).
01
Sampling period defined in increments of seconds (1-63 seconds).
10
Sampling period defined in increments of minutes (1-63 minutes).
11
Sampling period defined in increments of hours (1-63 hours).
Advanced Configuration
Use this command for advanced configuration parameters that apply to all sensor types. The advanced
configuration command is defined in the following table.
Byte
Description
0x01
Port number (LoRaWAN only)
0x02
Link quality check period (LoRaWAN only)
Port Number
For LoRAWAN devices only.
Byte 0x01 of the advanced configuration command changes the uplink port per the
LoRaWAN protocol. The default port is 2, and a value of 0 in this field means to leave it at the default.
This feature is available in firmware v1.4 and above.
Link Quality Check Period
For LoRaWAN devices only
. Setting this register causes the device to ping the network server periodically with a
requested ack. Typically used with unconfirmed messages, this feature creates a periodic confirmed message and
looks for the ack to ensure the device is still connected.
The following table shows this byte’s encoded bit definitions.
Available in firmware v2.0 and above.
Bit 7
Bits 6:0
0
Period defined in hours (1-127 hours).
1
Period defined in minutes (60-127
minutes)
