SETTING UP AND CONFIGURING THE DEVICE
22
Conduit
®
300 Series IoT Programmable Gateway MTCDT3AC-L4G1/-EN Hardware Guide
Installing a Micro SD Card
You need:
Phillips screwdriver
Micro SD memory card, user-supplied (see multitech.net for SD card details)
To install or replace the Micro SD card:
1.
Disconnect power to the device if it is connected.
2.
On the front panel, unfasten the screw securing the nameplate and remove it.
3.
Locate the SD card slot below the SIM card slot, if device is mounted horizontally (or to the left of it, if
vertically). If an SD card is already installed, gently push on it using your fingernail to release it and
remove with your fingers.
4.
With the new Micro SD card contacts facing up, if horizontally mounted, (or contacts to the right, if
vertically), gently push the card into the slot using your fingernail to secure it. Check that the card is in
the locked position.
5.
Reattach the nameplate using the screw removed in step 2.