Sg1400C3 STudio generaTor • operaTion manual — rev. #0 (10/05/11) — page 29
GEnEratOr OutPutS
generaTor ouTpuT volTageS
A wide range of voltages are available to supply voltage for
many different applications. Voltages are selected by using
the
voltage selector switch (Figure 10). To obtain some
of the voltages as listed in Table 9 (see below) will require
a fine adjustment using the
voltage adjust toggle switch
located on the digital control panel.
voltage Selector Switch
The voltage selector switch (Figure 10) is located on the
back side of the Saddle Box Assembly. It has been provided
for ease of voltage selection.
Figure 10. Voltage Selector Switch
.
120/208
277/480
120/240
3
1
3
CauTion
never change the position of the voltage selector
switch while the engine is running. alWaYS place
main circuit breaker in the
oFF position before selecting
voltage
and activate voltage change mode switch.
Table 9. voltages available
l1 l2 l3 output
Terminal lugs
voltage Selector Switch
3-phase 120/208v position
voltage Selector Switch
3-phase 480/277v position
3Ø
line-line
208V
220V
240V
416V
440V
480V
1Ø
line-neutral
120V
127V
139V
240V
254V
277V
voltage Selector Switch Single-phase 240/120v position
1Ø
line-neutral/
line-line
120V
Line-Neutral
N/A
N/A
240V
Line-Line
N/A
N/A
NOTICE
Controller has over/under-voltage protection based on
208 V nominal/480 V nominal/240 V nominal voltage.
generator amperage
Table 10 shows the
maximum amps the generator can
provide.
do noT exceed the maximum amps as listed.
Table 10. generator maximum amps
rated voltage
line amps
Total amps
1Ø 240 Volt
538 amps
1076 amps
3Ø 208 Volt
466 amps
1400 amps
3Ø 480 Volt
202 amps
606 amps
