MC-94P/S CONCRETE MIXERS — OPERATION & PARTS MANUAL — REV. #4 (11/04/05) — PAGE 13
MC-94P/S CONCRETE MIXER — MIXER BASIC COMPONENTS
1.
Steel Mixing Drum
— The
Multiquip
MC-94S uses a 6 cu.
ft
steel
mixing drum. This drum is to be used for mixing of
concrete. Always clean the drum after each use.
DO NOT
use this mixing drum for the mixing of
volatile liquids.
2.
Plastic Mixing Drum
— The
Multiquip
MC-94P uses a 6
cu. ft
plastic
mixing drum. This drum is to be used for mixing
of concrete. Always clean the drum after each use.
DO
NOT
use this mixing drum for the mixing of
volatile liquids
.
3.
Mixing Blades (Plastic)
— Used for the mixing of concrete.
Replace blades when they show signs of wear. Reference
plastic mixing drum in the parts section of this manual.
4.
Dump Latch
— To rotate the mixing drum, this latch must
be in the up position. To lock the drum, place the latch in the
down position.
5.
Dump Gear Guard
—
NEVER
operate the mixer with this
guard removed. Its purpose is to prevent dirt and debris
from entering the dump gear. In addition operator clothing
could become entangled in the dump gear, causing severe
injury and bodily harm.
6.
Handwheel
— Turn this wheel clockwise or counter-
clockwise to rotate the mixing drum. Remember the dump
latch must be in the
up position
in order for the mixing
drum to be rotated.
7.
Zerk Fittings
— There is, at the bottom and engine side
of the
yoke
, and center of the
handwheel
grease zerk
fittings. Lubricate these fittings as referenced in the
maintenance section of this manual.
8.
Safety Chain
— This mixer uses a 3/16-inch thick, 72-
inches long zinc-plated saftey chain.
ALWAYS
connect the
safety chain when towing.
9.
Tow Bar
— This mixer uses various towing bars, please
reference the frame assembly drawing and parts list in this
manual to determine which tow bar meets your
requirements.
10.
Leaf Suspension
— This mixer uses a leaf type
suspension. Check the mounting hardware for bolt hole
elongation and tightness. See maintenance section of this
manual for recommended maintenance.
11.
Chock Blocks
—
Place these blocks (not included as
part of the mixer package) under each mixer wheel to
prevent rolling, when mixer is not connect to the towing
vehicle.
12.
Tires Ply
— The tire ply (layers) number is rated in letters;
This mixer uses 13-inch 2-ply tires. Replace with only
recommended type tires.
13.
ON/OFF Switch (gasoline only)
— This switch is provided
on
mixers
with
gasoline
engines only and is located on
the side of the mixer frame. When activated it will shut
down the engine. Pull out when starting the engine.
14.
Cabinet/Latch
— Encloses engine and electric motor.
NEVER
run mixer with cabinet removed. Use latches to
secure engine compartment cabinet.
15.
Mixing Blades (Steel)
— Used for the mixing of concrete.
When blades show signs of wear, entire steel mixing drum
assembly must be replaced. See steel mixing drum
assembly in the parts section of this manual.
16.
Forklift Pockets
–
When lifting of the mixer is required,
use these fork lift pockets to lift the mixer. Remember to
insert the forks of the forklift a minimum of 24 inches into
the lift pockets.
Figure 2. Mixer Major Components
Discount-Equipment.com
Содержание MC94SH8
Страница 3: ...D i s c o u n t E q u i p m e n t c o m ...
