PAGE 18 — JS36 SERIES WALK-BEHIND TROWEL • OPERATION AND PARTS MANUAL — REV. #5 (06/02/16)
7. Adjustment of the throttle cable tension may be
required. If so, loosen the
adjusting nut
(top nut)
on the
throttle cable receiver (Figure 7) and loosen or tighten
the
locking nut
(bottom nut). Retighten
adjusting nut
.
Figure 7. Throttle Cable Receiver Adjustment
Safety Stop Switch Connection
1. Connect the black tail wire from the engine to the
top
black safety stop wire from the centrifugal stop switch
as shown in in Figure 8.
Figure 8. Safety Stop Switch Connection
2. Remove the existing bottom mounting screw on the
recoil starter cover (Figure 9) and connect the
bottom
wire from the centrifugal stop switch to this engine
ground point.
Figure 9. Engine Ground Point
ADJUSTING
NUT (TOP)
LOCKING NUT
(BOTTOM)
NOTICE
If the throttle lever does not return to the "neutral"
position with throttle backed off, loosen adjuster nut 1/2
turn at a time, tighten and recheck. Readjust throttle
tension as necessary.
SAFETY STOP WIRE
CONNECTION POINT
BLACK
TAIL WIRE
TOP SAFETY
STOP WIRE
CENTRIFUGAL
STOP SWITCH
ON
OFF
CENTRIFUGAL
STOP SWITCH
BOTTOM
EXISTING
SCREW
FUEL TANK
TOP
BLACK/RED
ENGINE
GROUND
POINT
RECOIL
STARTER
COVER
MALE
FEMALE
BLACK
BLACK
TAIL WIRE
ASSEMBLY AND INSTALLATION
Pitch Cable Installation
1. For
Standard Handle
models expose the pitch cable
to maximum by turning the blade pitch star wheel
(Figure 10) fully counterclockwise for no pitch (blades
flat).
Figure 10. Blade Pitch Star Wheel
(Standard Handle)
2. For
Quick Pitch™ Handle
models expose the pitch
cable to maximum by grasping the T-handle (Figure
11), then squeezing the trigger lock and pushing the
T-handle forward for no pitch (blades flat).
Figure 11. Blade Pitch T-Handle
(Quick Pitch™ Handle)
3. Remove brass set nut #1 from the blade pitch cable
end as shown in (Figure 12).
Figure 12. Blade Pitch Cable
4. Thread brass set nut #2 (Figure 12) towards the cable
as far as possible.
INCREASE
BLADE PITCH
(CW)
DECREASE
BLADE PITCH
(CCW)
T-HANDLE
TRIGGER
(SQUEEZE)
NO PITCH
FORWARD
BLADE
PITCH
CABLE
BRASS SET
NUT #1
BRASS SET
NUT #2
Содержание js36h55
Страница 43: ...JS36 SERIESWALK BEHINDTROWEL OPERATION AND PARTS MANUAL REV 5 06 02 16 PAGE 43 NOTES...
Страница 62: ...PAGE 62 JS36 SERIESWALK BEHINDTROWEL OPERATION AND PARTS MANUAL REV 5 06 02 16 ENGINE SERVICE PARTS 1 2 3 4 5...
Страница 64: ...PAGE 64 JS36 SERIESWALK BEHINDTROWEL OPERATION AND PARTS MANUAL REV 5 06 02 16 NOTES...
Страница 65: ...JS36 SERIESWALK BEHINDTROWEL OPERATION AND PARTS MANUAL REV 5 06 02 16 PAGE 65...
