MX1000HD-Xtream
Important Instructions
APRIL 17, 2015
VOLUME 1, NUMBER 1
“Make sure you
don’t Change any
Major Settings On
The Box or Install
or uninstall any
apps as this can
stop the auto
updates on the
box.”
MX1000HD-
Xtream TV
Box has an
exclusive
software
build
Auto Updates
Daily So You
Never Need
To Update
Anything
Confused Just
Contact Us
.
Quick 3 Stage Set-Up Instruction’s (Important)
1.
When first installing your new
MX1000HD Media Box
Please
Make Sure
you plug in the
HDMI and The Network Cables
First
before
you plug in
the Power Cable, Then Plug in the
Power Cable
to the Box
Last
.
2.
Now plug in the
power adaptor
and connect
power lead
to the
MX1000HD
it will power up straight away
and connect to your
router
.
After a few minutes the
“INSTALL BUILD”
Screen will appear as follows;
(If Not then the Build may have already been Pre-Installed for you
so ignore stage 3 below and you’re now ready to go)
3.
Install the New 2015 Build
You Must Select
“INSTALL BUILD”
Do NOT select anything
else or your upgrade build may fail and the box will need to be
returned for re-programing, just follow instructions below;
The First time you switch on your MX1000HD-Xtream Box You
Will May See A Main Screen with
“INSTALL BUILD”
in the
Main Ribbon Menu, You MUST Now Select
“INSTALL BUILD”
See on left,
Then Go through the on-screen questions and Agree To The
Disclaimer Messages that follow,
And select
“Reboot”
when asked to do so on the last screen.
Once you have selected reboot your box will reboot and
download the latest build software from the dedicated server,
this can take around 20 to 30 minutes and will re-boot 2 – 3
times
DO NOT SWITCH OFF or DISCONNECT THE BOX
FROM THE INTERNET
while this is taking place,
After 20 to 30 minutes you will see a new settings screen in the
new build, please wait a few minutes to allow for any online
app’s to fully update before normal use, now switch off the box
into standby wait 5 seconds and switch on again,
Quick Setup Over, That’s It, Now Sit Back And Enjoy
.
NOTE: You may have received your box with the new 2015
build Pre-Installed And Fully loaded, in this case just ignore
the “Install The New 2015 Build” Stage 3 Above.
Please Make Sure You Read Important Notes on “Settings” on
page 2 “PTO”