User Manual
101
select it again to switch to
Amplitude
). Set the parameter in the right menu.
To Set the Offset
Select
Offset
in the right menu (if
Offset
is not displayed, select
Low Level
and select it
again to switch to
Offset
). Set the parameter in the right menu.
To Set the High Level
Select
High Level
in the right menu (if
High Level
is not displayed, select
Amplitude
and select it again to switch to
High Level
). Set the parameter in the right menu.
To Set the Low Level
Select
Low Level
in the right menu (if
Low Level
is not displayed, select
Offset
and
select it again to switch to
Low Level
). Set the parameter in the right menu.
To Output Square Signals
The parameters of Square waveform are: Frequency/Period, Start Phase, Amplitude/High
Level, Offset/Low Level.
To set the Frequency/Period, Start Phase, Amplitude/High Level, Offset/Low Level, please
refer to
on page 99.
To Output Ramp Signals
The parameters of Ramp waveform are: Frequency/Period, Start Phase, Amplitude/High
Level, Offset/Low Level, Symmetry.
To set the Frequency/Period, Start Phase, Amplitude/High Level, Offset/Low Level, please
refer to
on page 99.
To Set the Symmetry of Ramp
Select
Symmetry
in the right menu of Ramp. Set the parameter in the right menu.
To Output Pulse Signals
The parameters of Pulse waveform are: Frequency/Period, Start Phase, Amplitude/High
Level, Offset/Low Level, Width/Duty Cycle.
To set the Frequency/Period, Start Phase, Amplitude/High Level, Offset/Low Level, please
refer to
on page 99.
To Set the Pulse Width of Pulse
Select
Width
in the right menu (if
Width
is not displayed, select
Duty Cycle
and select it
again to switch to
Width
). Set the parameter in the right menu.
To Set the Duty Cycle of Pulse
Select
Duty Cycle
in the right menu (if
Duty Cycle
is not displayed, select
Width
and
select it again to switch to
Duty Cycle
). Set the parameter in the right menu.
Содержание MP720021
