FS
5
Innovation. Quality. Performance. Best in Industry. Worldwide.
Fast Start Laser – MultiVision
1.
Turn on Power
Locate the power switch, the round knob in the control enclosure, and rotate it to the ON position.
Make sure that Suite4 and VisionTool4 or MultiVision are installed on the computer
Make sure the dongle is in place on the computer as the software will not run without the dongle.
2.
Turn on Air Pressure
Use the knob to adjust the air pressure.
Verify the pressure is between 80 and 100 psi.
3.
Open Gas Bottles
Turn the valve fully counter-clockwise (fully open) if used.
Verify the pressure is adequate for machines with capacitive height systems that cut ferrous metals and
machines with no capacitive height systems that cut non-ferrous metals.
4.
Turn on Laser
Rotate knob to the ON position.
Verify the chiller is turned on. The laser will not work without the chiller being on.
5.
Find Machine Hard Home
Press
Shift
and
Go Home
to find the hard home 0,0 or the machine home by indexing the gantry,
carriage, and Z assembly off of the proximity limit switches.
6.
Set Surface
for ferrous metals or machines with capacitive height sensors
Press
Jog Arrows
to position the
center of the head assembly
over the material to be
cut.
Press
Set Surface
.
Enter the material thickness.
Press
Z-axis Jog Arrows
to lower the Z-axis until the head assembly is approximately 0.25”
(6.35mm) above the material.
Press
Zero
to begin the surfacing routine. This will cause the Z-axis to move down slowly until the tool
comes in contact with the surface block and then move up above the surface block to the Lift Height.
Routers * Lasers * Plasma * WaterJets * Knife Cutters
www.MultiCam.com v. 11 10
