Multibor Podolog, Руководство пользователя

Страница: 15 / 24

Manual Mode
Switching between the manual and program modes is performed by
pressing the 'M-button' and is followed by an audible signal.
Switching between the modes is only possible when the tool
rotation is off.
In the Manual mode, the display shows only two or three digits,
which mean the tool rotation speed in thousands of revolutions per
minute (rpm).
The rotation direction is shown by the "running arrow" in the first
section of the indicator on the Display.
Attention!
The weight and mechanical balance of a tool have
significant influence on the vibration of the milling cutter. There is a
risk of damaging a tool at the speeds exceeding 30,000 rpm. The
milling cutter has two levels of rotation adjustment in order to
decrease the probability of accidents.
1. Fast and abrupt adjustment done literally during a single
revolution of the Manipulator for the speeds of up to 30,000
rpm only. In this case, a short audible signal indicates that the
first level speed is reached.
2. The increase of the speed exceeding 30,000 rpm will be done
slower. Actually, the Manipulator needs to be rotated for a
longer time while the speed increases slower.
15
Modes of Operation
Indications and Alarms in Different Modes
The handheld milling cutter can operate in two equivalent modes:
Manual mode
Program mode
For each of the modes, each type of indication is shown at the display
by means of a relevant combination of characters, digits, and
segments, and is also backed up by specific audible signals
In any mode, prior to switching on the tool rotation, its direction is
shown by an arrow on the Display.
If the arrow goes upwards
and to the right, the tool
will rotate clockwise.
If the arrow goes downwards
and to the left, it means that
the "Reverse" function is
activated and the tool will
rotate counterclockwise.