5
Basic control principles
Switching on the terminal
20
V5.20170221
31302713-02-EN
Basic control principles
Switching on the terminal
To switch on the terminal:
The terminal is installed and connected to the power cable or the ISOBUS basic vehicle harness.
1.
Press and hold the
button for approx. 3 seconds.
⇨
The terminal will beep briefly.
⇨
The terminal screen remains dark for approx. 10 seconds until the applications are loaded in
the background.
⇨
The Start screen of the terminal will appear:
⇨
You have now started the terminal.
Initial start-up
The next step to perform after switching on the terminal depends on the purpose of the terminal:
▪ Parallel guidance
▪ Operation of ISOBUS implements
▪ Automatic section control
▪ Task processing and documentation
These cases will be described in the following sections.
Using the terminal for parallel guidance
If you want to use the terminal for parallel guidance, TRACK-Leader is the most important app for
you.
Most important settings
Setting
Where?
Purpose
Select the GPS driver.
/ Driver / GPS [
The standard driver works in
most cases for the receivers
sold by ME. However, to
change the correction signal, a
fitting driver for the GPS
5
5.1
Procedure
5.2
5.2.1
