Muller Elektronik TANK-Control II, Инструкция по установке и эксплуатации

Страница: 44 / 66

9
"Tank Control II" menu - Filling and operation
Displaying the workable area
44 V2.20161017 30252060-02-EN
Displaying the workable area
If you are using one tank and one sensor, the workable area is displayed by default in the "Tank
Control II" menu.
If you are using two tanks and two sensors, you can display the workable area in the "Tank Control II"
menu as follows:
Display Meaning
Area that you can spray with the fill level in tank 1. For example, if you only apply
the spray liquid from tank 1.
Area that you can spray with the fill level in tank 2. For example, if you only apply
the spray liquid from tank 2.
Total area that you can spray. For example, if you apply the same spray liquid
from both tanks.
To change the display if you are using TANK-Control II with two tanks and two sensors:
1. Open the "Tank Control II" menu.
2. Press the key until you can see the tank required or both tanks for use in the
calculation.
⇨ The workable area display changes depending on what you select.
Controlling external devices
TANK-Control II can control operation of the following external devices:
▪ - Filling pump
▪ - Ball valve
▪ - Agitator
Activating and deactivating external devices
When using external devices, you can select whether the devices are activated or deactivated.
You can activate or deactivate all external devices on the following screen:
9.4
Procedure
9.5
9.5.1
www.ROLTRONIK.pl