"Sensors" menu - configuration and calibration
Carrying out calibration
8
30252060-02-EN
V2.20161017
31
Carrying out automatic calibration
During automatic calibration you will often see the following screen:
Automatic Calibration screen
Current calibration point
Current float height in mm
Next activity, either drain or fill, in this case:
drain
NOTICE
Inaccurate calibration due to incorrect fill volume
If the configuration is wrong the fill level cannot be measured accurately. This makes all calculations
imprecise.
When calibrating the tank:
◦ Use a flow meter or a weighbridge.
WARNING
Danger of poisoning from spray liquid residues
When configuring the tank:
◦ Always use clean water.
You have set the tank size.
You have completed the 100 litre calibration.
You have planned the float heights at which you want to enter the fill level.
You have pen and paper to hand to write down the fill levels.
1.
Open the "Sensors" menu.
2.
Press:
>
>
>
8.5.2
Procedure
www.ROLTRONIK.pl
Содержание TANK-Control II
Страница 65: ...w w w R O L T R O N I K p l...
Страница 66: ...w w w R O L T R O N I K p l...
