Muller Elektronik SMART570, Инструкция по установке и эксплуатации

Страница: 13 / 30

Basic control principles
Initial start-up
5
30322507-02-EN V7.20210115 13
Basic control principles
Initial start-up
For the initial start-up, you must switch on and configure the terminal.
 The terminal is installed and connected to the ISOBUS.
1. - Start the terminal.
⇨
The terminal will now be started.
⇨
Each time the terminal is started, it checks whether unknown job computers are connected
to the ISOBUS. If yes, the terminal then copies the information from the job computer. This
can take a little while.
⇨
If a joystick or other operating device is detected, you will be requested to confirm the button
assignment [
➙
16].
⇨
The following screen appears:
⇨
You can change the system settings through this screen.
2. Configure the system settings [
➙
18].
3. Configure the speed sensor [
➙
20].
⇨
You have configured the terminal.
Operating the terminal
The terminal can be operated either using the buttons on the casing and the rotary encoder or directly
with the touch function of the screen.
All functions of the terminal can be executed using both operating methods.
Operating the terminal using the buttons and rotary encoder
The following functions can be executed with the rotary encoder:
Illustration Action Function
/
Turning the rotary
encoder Moves the cursor up or down.
Changes the value of a parameter.
5
5.1
Procedure
5.2
5.2.1
Rotary encoder