Configuring the job computer for work
Configuring sections
7
30322453-02-EN
V4.20191001
49
4.
- Save the minimum fill level of the tank.
5.
Fill the tank completely.
6.
- Save the maximum fill level of the tank.
⇨
You have calibrated the fill level sensor.
Configuring sections
Before you start working, you must configure the individual sections of the mounted implement.
Note that the working width of the slurry tank cannot be changed separately. The working width
always consists of the sum of all of the sections.
If you are using a slurry tanker with only one section, you must enter the entire working width in the
field for section 1.
Activated sections
Blocked for tramlines
Number of the section
Blocked sections
Section width
Tractor side on which the sections are located
Icon
Meaning
The application is not blocked for any tramline.
The application is blocked for one tramline on the left side.
The application is blocked for one tramline on the right side.
The application is blocked for tramlines on both sides.
Icon
Meaning
The section is open.
7.5
