7
Configuring the job computer
Configuring the control units
58
V1.20180921
30303187-02-EN
“Pump” parameter
When the pump speed is higher than the maximum permitted pump speed, an error message
appears. This allows drivers to have better control of their work and prevent the pump from being
damaged when the speed is too high.
The parameter includes two values:
▪ “Current”
Indicates what the maximum pump speed is currently set to.
▪ “Target”
Used to change the maximum pump speed.
To save the current pump speed as the maximum permitted speed:
1.
Highlight “Set value” line.
2.
Run the pump speed up to the desired value.
⇨
The current pump speed will be shown on the “Set value” line.
3.
- Press.
⇨
The pump speed from the “Set value” line appears in the “Current” line. In this way it has
become the maximum permitted pump speed.
“Section Control” parameter
Manner in which the sections are switched on and off.
▪ “Sequential mode” [
This type is intended for normal spraying work. It is also suitable for spraying on wedge-shaped
areas and strips that are narrower than the working width of the field sprayer.
“Filling Mode” parameter
With this parameter, you can define whether you want to use TANK-Control for filling.
▪ “Manual” - For field sprayers without TANK-Control.
▪ “TANK-Control” - Activates TANK-Control.
“Circulation Type” parameter
▪ “Non constant pressure”
For manifolds without the “Constant pressure” function.
▪ “Constant pressure”
For manifolds with the “Constant pressure” function.
Configuring the control units
The joystick and S-Box control units are configured on a screen.
▪ “
Joystick
” parameter:
– “Without Joystick”: Joystick is not connected. All functions will be controlled using the
terminal or an ME S-Box.
– “ME Joystick”: ME Joystick is being used.
7.1.16
Procedure
7.1.17
7.1.18
7.1.19
7.2
