Operating the system
Driving in reverse
5
30322332-02-EN
V2.20160912
19
1.
Drive the tractor to the right
2.
/
- Steer the trailed implement for driving to the right.
⇨
With drawbar steering: The drawbar is steered to the left.
⇨
With axle steering: The wheels are steered to the left.
⇨
An arrow pointing left appears on the work screen:
To drive straight ahead again:
1.
Drive the tractor straight ahead.
2.
/
- Steer the trailed implement to the middle position.
⇨
The trailed implement slowly moves to the middle position.
⇨
An arrow appears on the work screen. It shows the direction in which the drawbar or axle is
steering.
Drive in a curve to the left as follows:
1.
Drive the tractor to the left
2.
/
- Steer the trailed implement for driving to the left
⇨
With drawbar steering: The drawbar is steered to the right.
⇨
With axle steering: The wheels are steered to the right.
⇨
An arrow pointing right appears on the work screen:
Driving in reverse
The operation of the trailed implement when driving in reverse depends on several factors:
▪ If no reverse driving signal [
31] is available, you can deactivate TRAIL-Control or set it to
manual mode before driving in reverse.
▪ As a standard, TRAIL-Control stops working if a reverse driving signal is detected. In this case,
the automatic mode remains activated, but the hydraulic valves are not being controlled.
▪ You can configure the reaction for TRAIL-Control when a reverse driving signal is detected. To
do so, read section: Configuring automatisms when driving in reverse [
When a reverse driving signal is detected, a flashing icon always appears on the work screen.
Steering the trailer device against the slope
For working on slopes, you can use the 'slope counter-steering' function.
When you activate the 'slope counter-steering' function, you can offset the track of the trailed
implement to the left or right. The direction in which the track is offset depends on if the slope climbs
or declines to the left or right of the implement.
The aim of the "slope counter-steering" function is to prevent the trailed implement from driving
inclined to the direction of work on a slope.
Procedure
Procedure
5.4
5.5
Mode of operation
