7
Configuring the job computer
Entering sprayer parameters
40
V1.20190404
3030383000-02-EN
Configuring the job computer
Entering sprayer parameters
Enter the parameters in the following cases:
▪
Prior to initial start-up.
▪
When the sprayer parameters change.
To change the value of a parameter:
1.
Switch to the “PARAMETERS” screen:
⇨
The “Parameters” screen appears.
⇨
A small rectangular box with a value appears under each parameter.
2.
Select this box to change a parameter.
⇨
Screen for data input or keyboard appears.
3.
Enter desired value.
⇨
The new value appears on the “Parameters” screen.
The parameters appearing on your screen depend on the type and configuration of your sprayer.
“Target Rate” parameter
The quantity entered as the target rate will be applied when the sprayer is working in automatic
mode.
“Product” parameter
Product that is being applied. The factor with which the “Impulses main flow” parameter is multiplied
appears beside the product.
“Working Width” parameter
Working width of sprayer.
“Wheel Impulses” parameter
Number of impulses the wheel sensor sends to the job computer on a 100m distance. Used to
calculate the speed.
The number is determined by the wheel sensor calibration.
“Minimum Pressure” parameter
This setting defines the minimum pressure up to which the spraying pressure is optimal.
If the spraying pressure drops below the defined pressure, an alarm is issued.
If no pressure sensor is installed on your sprayer, you must enter “0” as the value.
7
7.1
When to enter?
Procedure
7.1.1
7.1.2
7.1.3
7.1.4
7.1.5
