DLE-60CC EFI UAV ENGINE
1
0
3.2 Throttle Setting
1. Throttle commands use standard RC TX/RX or flight controller. The voltage of throttle
servo installed on the engine is 6V-7.4V by RX or Flight Controller Channel
2.
Before starting the engine, adjusting the exponential rate of TX throttle curve or flight
controller to get the desired throttle response with throttle air valve, which affects the
engine performance
Full Throttle O
n
Full Throttle Off
3. Our EFI system does not need extra Throttle Kill Switch, the engine will stop and
automatically the power for fuel pump is cut off when throttle air valve is fully off.
4. For UAV project with the engine applied, providing power to the enable line of
ECU,when the signal of flameout is given, the enable line on an optional module (not
recommend) will stop the engine. For most flight controllers on the market, 10% rate for
idle RPM is set and will not stop the engine until turning off the button on the flight
controller. Suggest the user to set up the idle rate on your TX or flight controller for the
first time to operate the engine
. Properly adjust and set up the throttle curve and rate to
avoid the damage of throttle servo by dead steering.
MUGIN LIMITED
WWW.MUGINUAV.COM