Series 111 Accumulators
Installation
9
Installation
There are two models of the Series 111 Accumulator. The following figure
shows the typical mounting configuration for the Models 111.11B and
111.12C Accumulators.
•
The Model 111.11B Accumulator is mounted with a boss adapter
fitting and O-ring seals. When the accumulator is ordered as a
component, the boss adapter and O-ring seals are not included with
the accumulator, they must be purchased separately.
•
The Model 111.12C Accumulator is flush mounted with four bolts and
O-ring seal(s). When the accumulator is ordered as a component, the
four bolts (grade-8) and O-ring seal(s) (max. size 54.28 mm [2.137 in.]
outside diameter, 47.22 mm [1.859 in.] inside diameter), are not
included with the accumulator and must be purchased separately.
Mounting Configurations
Required equipment
The following equipment is required for accumulator installation:
•
Open-end wrench and strap wrench (for the Model 111.11B)
•
Hex key set and torque wrench (for the Model 111.12C)
Boss Adapter
Mounting
O-Rings
111.11B
111.12C
3
1
2
4
Accumulator
Mounting
Bolts (4)
Flange
Mounting
O-Rings
Flange
Mounting
Bolt
