Bottle Loading
Set-Up Instructions
•
Remove the cooler from the shipping box and verify that there is no
damage to cooler.
•
Ensure cooler is located on a level floor out of direct sunlight.
•
Wipe water bottle with a damp cloth and remove label from the No
Spill cap. Insert dip tube into bottle.
•
Place the bottle on the base and close the door until it is in the
locked position.
•
Ensure that the hot tank switch on back of unit is in the “Off”
position.
•
Connect cooler to power source (
do not use an extension cord
).
This water cooler is intended to be plugged into a receptacle of the
ground fault circuit interrupting type (GFCI).
•
The AquaCafe® r has a self-priming feature that takes
approximately 5 minutes to fill both the hot and cold tanks. After
that time, dispense water from both the hot and cold tanks to
confirm that they have filled. Then turn on the hot tank.
Note: The maximum water supply should not exceed 80 psi.
MTN Products, 1770 Brackett Street, La Verne, CA 91750, 909-629-7301
ACB210r-T QSG Rev: 12/16/2015
MTN Products
AquaCafé® r (Touch with Bottle Water)
Quick Start Guide
