770-00008
Revision 1.1, Copyright © 2020, Impinj, Inc.
Revision 1.2 Copyright © 2020, Microelectronics Technology, Inc.
1
MTI M200-RS Development Kit
Quick Start Guide
Introduction
This document describes how to start reading UHF RFID tags with the MTI M200-
RS pin-to-pin, 100% compatible module for Indy® RS2000 Development Kit.
Kit Contents
•
RS2000 Development Board
•
Kit Quick Start Guide
•
USB drive containing software tools and
documentation
•
Impinj Mini-Guardrail Antenna
•
Laird Far Field Antenna
•
12 Volt DC Power Supply
•
SMA RF Cable
•
Mini-USB Cable
•
RAIN RFID Tag Samples
•
M200-RS Module Samples (2)
Getting Started with the M200-RS Development Kit
1. Install the Indy Demo Tool software on your Windows PC.
a. Copy the
Indy Demo Tool.exe
file from the USB drive.
2. Configure the M200-RS development kit hardware as shown in
a. If you have reconfigured the jumpers since opening the kit, restore the default configuration as described in
the “Kit Default Configuration” section of the
b. Connect the kit PCB to your PC using the Mini-USB cable.
c. Connect the 12 Volt DC power supply to a power source, and the kit PCB
i.
At this point, the green
“Health” LED on the right edge of the kit PCB should start blinking.
d. Connect the ANT1 port (J201) on the kit PCB to the Mini-Guardrail antenna using the SMA RF Cable.
e. Place one of the UHF RFID tags on top of the antenna.
