MTI 526, Руководство пользователя

Страница: 12 / 28

8 User Manual | MTI 527, 527W, & 526
Unpacking and Set-up
1. Remove shipping straps,
shipping box, and other
boxes from the pallet.
2. Remove (4) shipping bolts
with 7/16" end wrench.
3. Remove braces from the
top of baseplate. Braces will
vary for swivel/mobile bases.
4. Slide chair off pallet. To
move equipment, lift only
from the equipment’s main
structure. Recycle or re-use
pallet.
Yellow
5. Insert power cord at
the base of the chair and
secure with the clip. Plug
the power cord into the
provided surge protector.
Plug the surge protector
into an appropriately marked
receptacle.
6. Install control(s) by
aligning pins and tabs of the
male control plug with chair
receptacle by positioning
the yellow mark on the
plug body to the 12 o’clock
position relative to the
receptacle.
7. Secure the plug by
rotating the locking ring
clockwise until it engages.
Rotate it until it stops.
Steps 8 through 9 do not
apply to mobile base chairs.
8. If chair base plate needs
to be leveled, remove (4)
acorn nuts from the top
of the glides with a 5/8"
wrench, otherwise proceed
to step 10.
9. Adjust individual glides to
level the chair as needed
using a screwdriver. Reattach
the acorn nuts.
10. (Designer Upholstery
Only) Install the upholstery
flap between the back and
seat cushions, laying the
flap over the back hinges
and securing the flap to
the Velcro
®
strips on the
chair’s back section and seat
section.
11. (Designer Upholstery
Only) Install the seat
cushion by placing the
cushion against the hinges
and then lowering it to the
front of the seat. Verify that
the cushion is centered.
12. (Designer Upholstery
Only) Align the back cushion
with the top edge of the
back of the chair. Press
cushion down. Verify that
the cushion is centered.