1
1
3
2
3
2
SECURE PLUG
™
PRODUCT MANUAL
5
MTI P/N 063-00243 rev D ©2019 MTI All Rights Reserved
www.mobiletechinc.com | T:800.426.6844
MERCHANDISING
KEY SETUP
Swipe User Key you wish to setup.
If successful
unit beeps 2 times
If unsuccessful
unit beeps 4
times (retry)
Repeat process for all User Keys
until they are successfully added.
Swipe Authorization Card again to
end key setup.
Secure Plug will automatically exit
key setup mode 3 minutes after
the last User Key is added.
Swipe Authorization card.
Plug your device’s power cord and/
or power supply into the Secure
Plug power strip.
Note: If your device has a two-piece
power cord/power supply, connect
those pieces before merchandising.
The LED on the Secure Plug and
RAM will then flash white and
single beep while calibrating, then
flash green and double beep once
calibration has completed (this
can take up to 2 minutes).
Plug the power source into the
device any time after the Secure
Plug/RAM has flashed green but
before arming.
Repeat this process for additional
devices.
The device end of the
power cord and/or power
supply must
NOT
be
connected to the device.
-CONTROLLED DOCUMENT-
063-00243
D-0
Status: Approved
ECO-109326
ECO-109326