Soft Touch Rev Control
PN 8728
Note:
This Soft Touch Rev Control, PN 8728, is designed for inductive style ignition systems only.
It
cannot be used with an MSD Ignition Control!
Parts Included:
1 - Soft Touch Rev Control
4 - Mounting Pads and Sleeves
4 - RPM Modules, 3,000, 6,000, 7,000, 8,000
4 - Wire Splicers
4 - Self Tapping Screws
4 - Wire Insulating Caps
Note: The RPM limit is set with plug-in rpm modules. If an rpm module is not installed, there will be
no rpm limit.
CyliNdeR SeleCT
The Soft Touch Rev Control comes from MSD
programmed for 8-cylinder applications. It can
easily be adjusted for operation on other en-
gines by cutting the cylinder select wire loops
(Figure 1). If the loops are cut, use the supplied
insulating caps to seal the wire ends.
MOUNTiNG
The Rev Control can be mounted in the engine compartment
but away from direct heat sources. It is recommended to
mount it where the rpm module is easy to access for rpm
adjustments. Make sure all of the wiring reaches their con-
nections. Once a suitable mounting location is determined
mark the location of the mounting holes by using the unit
as a template. Remove the unit and use an 1/8” bit to drill
the holes. Install the supplied mounts and use the four self
tapping screws to secure the Control (Figure 2).
WARNING: During installation, disconnect the battery cables. When disconnecting the battery,
always remove the Negative cable first and install it last.
Figure 1 Selecting the Number of Cylinders.
Figure 2 Installing the Vibration Mounts.
M S D I G N I T I O N
• w w w . m s d i g n i t i o n . c o m • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • FA X ( 9 1 5 ) 8 5 7 - 3 3 4 4
