MOUNTING
The Launch Master can be mounted in any position but keep in mind to mount it so the rotary dials
are accessible for adjustments. A section of Velcro is supplied for mounting. Double sided tape or
tie wraps are also recommended depending on the final mounting area. Before mounting the unit,
confirm that the wiring harnesses reach their connections.
Parts Included:
1 - Launch Master, PN 4351
MSD Powersports Launch Master
4-Cylinder, Two Coil, Wasted Spark
PN 4351
1 - Harness
Note:
The Launch Master is a launch rpm limiter that will not provide nor modify any over-rev protection.
The stock high rpm rev-limiter will still be active.
The MSD Powersports Launch Master is a universal launch rpm limiter. The Launch Master will
provide consistent launches and quicker 60-foot times. RPM adjustments are made via two rotary
switches located on the harness side of the unit. The adjustment range is from 1,800 to 9,900 rpm,
in 100 and 1000 rpm increments. An LED will illuminate when the launch rev limit is active.
Note:
It is recommended to have the service manual for your motorcycle.
4-WIRE CONNECTOR
TAN (2)
Signal Connections (Negative side of coils).
12-Volt Connection through this single Red wire (Positive side of coils).
RED
BLACK
Connects to a good engine ground or the negative battery terminal.
BLUE
Activation Wire. When grounded, the launch feature will be active. The harness
is supplied from MSD for a ground activation.
2-WIRE CONNECTOR
WHITE/BLUE
Activation Wire. When switched to 12 volts, the launch feature will be active. (The
position of the blue wire on the connecting 3-pin harness must be moved.)
Note:
Never connect both the Blue and White/Blue wires at the same time.
Note:
The stock clutch lever or aftermarket clutch lever with momentary switch
can be used to activate the Launch Master.
WIRING
LED
The built-in LED will illuminate when the Launch Master is activated.
1 - Velcro strip
1 - Parts bag
MSD POWERSPORTS
•
WWW.MSDPOWERSPORTS.COM
• (915) 858-3365 • FAX (915) 858-3496
