MSA SUPREMA Touch, Инструкция по установке и обслуживанию, Страница: 206 / 309

MSA AUER
MSA
Installation
SUPREMATouch 205
US
10.11 Connection for the System Power Supply
Before beginning installation, make sure that chapter 10.7, has been read and understood. Care
must also be taken to ensure that the complete system, including the sensors and relay modules,
does not exceed the maximum load of the selected supply voltage. If an external power supply or
a battery is used, the supply voltages must operated via an appropriate EMC filter. The require-
ments of the EMC and Low Voltage Directive must be complied with.
Calculation of the Required Power Supply
The power consumption for supplying the sensors is based on the number and types of connected
sensors and on the resistance of the cables used.
Fig. 147 Power Requirement of the Sensors and Cables
* Value applies to a bridge current of Ibr = 300 mA
** Only detector and source greater than 6 W. Both (detector and source) should be supplied by
external voltage source.
Type of Sensor Sensor Power Power per Ohm of Cable Resistance
Series 47 K 1,5 W 0.1 W*
SafEye 8 W** 0.1 W
GD10 3,5 W 0.05 W, max.
Ultima X 4 W 0.1 W
Ultima X IR 7 W 0.1 W
FlameGard 5 W 0.1 W
PrimaX I 1 W not applicable
PrimaX P 2,5 W 0.05 W
PrimaX IR 5 W 0.1 W
FlameGard 5 MSIR 3,6 W 0.1 W
FlameGard 5 UV/IR 3,6 W 0.1 W
FlameGard 5 UV/IR-E 3,6 W 0.1 W
Ultima MOS-5 5 W 0.1 W
Ultima MOS-5E 5 W 0.1 W
Ultima OPIR-5 10 W 0.1 W
UltraSonic EX-5 5 W 0.1 W
UltraSonic IS-5 2,5 W 0.05 W