•
Mesh face shields are not suitable for wildland firefighting and only suitable for non-firefighting associated activities
such as wood cutting, road clearance, etc. Additionally, they should not be used where there is a risk of exposure to
heat, flame, sparks, splashes of harmful or molten liquids, or electricity.
•
Visors meeting the requirements for electrical properties according to EN 14458 provide limited protection (brief
accidental unintended contact with live low voltage conductors), and all component parts of a visor/helmet assembly
shall have the same marking to achieve this.
•
Visors worn over non-designated corrective frames may transmit impacts which may damage the corrective eyewear
thus creating a hazard to the user.
•
Keep the ocular visor in standby position (stowed under the helmet shell) during the use of a breathing apparatus
(SCBA).
•
Service life of visors depends on the conditions of use.
•
Any visor or face shield that has been dropped or damaged must be replaced.
•
Visors shall be regularly inspected. Any visor with a scratched or damaged lens must be replaced.
•
Materials that come in contact with the wearer's skin could cause allergic reactions in susceptible individuals.
Failure to follow these warnings can result in serious personal injury or death.
4.2.1 Ocular Visor (GA3702)
Installation
(1)
Insert the plastic clips in the shell slots until they click
in position.
Removal
(1)
Push the plastic clips and slide them out of the
attachment slots.
WARNING!
With the ocular visor in the working position and adjusted, if there are gaps between your face and the spectacles that
could let external agents intrude and cause damage to your eyes, use safety glasses under the spectacles. Safety
glasses MUST comply with the applicable requirements of the latest revision of ANSI/ISEA Z87.1.
Failure to follow this warning can result in serious personal injury or death.
Use
(1)
Position the ocular visor in-use by pulling it down.
10
US
4 Accessories