MRV Communications LX-8000 Series, Руководство пользователя

Страница: 25 / 65

451-0331
MRV Communications, Inc. www.mrv.com
25
Chapter 3
Configuring the LX-8000 Series for the First Time
Configuring the LX-8000 Unit for the First Time
You can choose from five options to configure the unit for the first time:
• First Time Configuration Utility - The first time an LX-8000 unit boots up at default
parameters, you are presented with the option to run the Initial Connectivity setup. Enter
y
and press <Enter>. Refer to “First Time Quick Configuration” for further details.
• Assign the IP Address via the Network - Refer to “Assigning an IP Address via the
Network” for further details. Use this option if your network is using DHCP, BOOTP, or
RARP.
• Setting the IP Address Manually - Refer to “Manually Setting the IP Address Via the
CLI”.
• Creating and Loading a Default Configuration File - Refer to “Applying Default
Configurations to Other Units” in the LX-Series Configuration Guide .
• Configuring the LX-8000 Manually via the CLI - Refer to “Upgrading Software with the
ppciboot Main Menu” in the LX-Series Configuration Guide .
First Time Quick Configuration
NOTE: The first time quick configuration runs only on the DIAG port (port 0) on all models
when booting from default parameters. The DIAG port (port 0) of the LX-8020 and
LX-8040 is on the front of the unit.
NOTE: Display problems may occur during bootup when you attach a terminal to the DIAG port
(port 0) and the display setup is configured to
Smooth-2 Scroll
. To avoid this, change the
scroll setting to
Jump Scroll
.
Use the following procedure to configure your LX-8000 unit for the first time.