MRMC MRMC-2000-00-JB-0053, Быстрый старт

Страница: 14 / 64

Studiobot TX90 Quick Start Guide
10
Mounting the Weight Plates (Studiobot TX90 on
Pedestal)
1. Use the jack screws on the castor wheels to lift the base high enough
to insert each of the weight plates on either side of the Studiobot
TX90 Base lining up the screw cavities.
2. Lower the base close to the wing but not quite resting on it, close
enough for the two retaining bolts to reach the wings through the
base.
3. Secure the weight plates using the 2xM10 screws on either plate.
4. Lower the base completely so it is resting on both wings. At this
point, you can remove the castor wheels, if so desired.
5. Put the weights onto the wings. Studiobot TX90 requires four boxes
of weights — one at each corner. Each box contains 140kg of weights
(7 × 20kg).
Hint
You can move Studiobot TX90 without removing the wings if you
want, as long as you take the weights off first.
1
2
3
5