MRMC MRMC-2000-00-JB-0053, Быстрый старт

Страница: 11 / 64

Studiobot TX90 Quick Start Guide
7

Always run any move or adjusted move slowly at first to check
the motion. Even if you have checked the move previously, if
you make a minor change to it then you need to recheck it.

Keep the software in “slow mode” unless the move has been
tested and is now specifically doing a high speed pass.

In the event that a person or Actor has to be within the no-go
zone during a move (hand model etc.) ensure that they are
fully briefed on the safety requirements and that they know not
to change their position or do anything other than the
rehearsed moves without fully warning the operator. Any such
person is to have a clear escape route to allow them to move
safely away from the robot.

During use, repeatedly check the rig mounting points, cables,
camera mount, accessories etc. to ensure nothing has, or is,
working its way loose.

Never bypass any safety hardware or software.
Mounting the Castor Wheels (Studiobot TX90 On
Pedestal)
If the castor wheels are not mounted, use the following procedure to
mount the castor wheels:
1. Gently tip the base over from the top so its bottom is visible.