MRMC MRMC-1488-00, Быстрый старт

Страница: 23 / 52

AFC (MHC) Quick Start Guide
19
LAN settings of the devices so that the devices not only work together,
but do so when connected to another network. For example:

If you install the head as part of a multi-component system.

If you connect your MRMC equipment to a local network.

If you move the equipment between networks.

If you have customised the LAN settings in a head for one of
the above reasons and then sent the head back to MRMC for
servicing. The service might change the LAN settings back to
the factory defaults, and you will need to customise them again
when you get the head back.
Introduction to LAN addresses
Each device on an Ethernet network has a suite of three addresses:

Internet Protocol (IP) address

Subnet (SN) address

Gateway (GW) address
Together, these addresses indicate the device’s identity and location on the
network. Each address is usually written as a group of four numbers
separated by periods. The factory default values used in MRMC
equipment are shown in the next table:
Head
IP address 192.168.1.235 192.168.1.236
SN address 255.255.255.0 255.255.255.0
GW address 192.168.1.1 192.168.1.1
On a given local network, the last group of
numbers in the IP address must be unique
for each device. All other numbers and
addresses must be identical.