MRMC MRMC-1120-02, Быстрый старт

Страница: 9 / 20

Quad Box Quick Start Guide
5
Trigger connector (trigger out and in)
Trigger connection with Trigger Out
and Trigger In connections.
1. GND
2. Trigger Out
3. Trigger In/Out
4. +5V
Pin 3 can be trigger input or output
depending on a jumper setting in the
box which is set during manufacture. DSLR applications typically use two
trigger outputs, on pins 2 and 3; one for shutter and one for auto-focus.
Video applications typically use pin 2 for trigger output and pin 3 for
trigger input.
Adding a Quad box in Flair
When a new Turntable, other model mover or motor driven by a Quad
box needs to be added to a Flair system, there is a set of steps that need to
be followed to get this information on the nature of the item into Flair so
the network can detect it and load it on bootup.
Devices are added to the network as nodes identified by their IP address,
and it is possible that there may be duplicated IP addresses which will
need to be handled before this is possible.
The additional Quad box will need to have an Ethernet cable connected
to the Ethernet hub of the Flair system, and be powered.
1. Edit the file
C:\Flair\Flair6\Flair.ini
. This file is a text file
that you can edit with any text editor such as Notepad, either
directly or by using the Flair menu option
Help > View .ini File .
You need to add or edit some lines in the file similar to the following
lines.
*NetworkBoards: 3
*NodeProgram3: Quad6Ether_II.btl
The keywords used in the above table are described below:

*NetworkBoards
: This line shows the number of network
boards (nodes) in the system. You need to increase this by one
3
4
2
1