MRMC MOVER RV13, Быстрый старт, Страница: 37 / 44

RV13 Model Mover Quick Start Guide
33
connection), and for updating the firmware in the Ulti-box. For
pin-out information see
Program serial connector
on page 35.
3.
POWER
DC input for the Ulti-box and its attached devices. The
standard unit uses a power input of 24-36 Volts. The high-power
variant (marked
HV
, for
H
igh
V
oltage) uses 24-48 Volts. For pin-out
information see
Power connector
on page 36.
4.
CAM ACC
Camera Accessory input/output connector. It has pins for
three stepper motors, two serial lens controls, two trigger in
controls, and two trigger out controls. For pin-out information see
Camera Accessory connector
on page 36.
5.
DATA
DataLink In (Up Link) connector for controlling the Ulti-box
and its attached devices using a DataLink connection, as an
alternative to an Ethernet or Serial RS232 connection. You connect
this to a device that is further up the DataLink daisy-chain, such as:

The
DATA OUT
(or
DOWN LINK
) connector on a controller
such as the MSA-20 Handwheels or Large Format Panel (LFP).

The
RIG/HEAD
connector on an RT-14 interface box which is
in turn connected to a PC running Flair Motion Control
Software.
Note that because there is no DataLink Out connector on the
Ulti-box, the Ulti-box must be connected at the end of the DataLink
daisy-chain rather than the middle. For pin-out information see
Data In connector
on page 37.
6.
ETHERNET
RJ45 connector for controlling the Ulti-box and its
connected devices from a Flair PC. This Ethernet port is rated at 100
Mbits/sec but can operate at lower speeds of 10 Mbits/sec or less.
7, 8.
ZOOM
,
FOCUS
connectors for external servo LCMs mounted on
the camera platform. For pin-out information see
Servo motor
connector
on page 35.
9.
TILT
connector for a Tilt servo motor on a head. For pin-out
information see
Servo motor connector
on page 35.