RV13 Model Mover Quick Start Guide
20
Starting up the RV13 Model Mover system
Once you have attached all the cables, you power up the rig by switching
on the components in the order described below.
1.
Make sure you have secured the area around RV13
Model Mover. Put up guard rails around RV13 Model
Mover as necessary, and tell others on the set that you
are now powering up the rig.
2.
Power up the CR800 controller. Wait for the robot to boot up for a
few seconds.
The RV13 Model Mover start up sequence on the CR800 controller (digits
on front panel)
Power
Auto
Error
Ready
LAN
Power up
I
I
I
I
I
I
I
F
I
F
F
F
I
I
I
I
Power switch
Hint
Ensure that the Flair PC is not plugged to the same
power strip as the CR800 Controller.
Содержание MOVER RV13
