MRMC MILO MRMC-1100-00, Быстрый старт, Страница: 26 / 44

Milo Quick Start Guide
22
Mounting the rig on a track
The procedure used to mount the Milo on track depends on the type of
wheel system that your Milo includes. If the Milo is provided with
traditional steering wheel system, then it is mounted using the ramp-ups;
if it bears the newer caster wheel system, then those are used to wheel the
Milo on to the track. Use one of the applicable methods detailed below to
mount the rig on to track.
Mounting the rig using ramp-ups
1. Roll the rig to a position just off the end of the track, ensuring that
the track pinion on the rig is on the correct side of the track.
2. Mount the ramp-ups on to the side of the track. Roll the rig over to
the ramp-ups to raise the rig high enough over the track so that the
track motor gear on the underside of the rig completely clears the
rack (the middle rail on the track). Push the rig to the position over
the ramp-ups so that the track motor gear on the Milo underside is
on the toothed side of the rack.
Do not engage the teeth yet; just
make sure Milo is the correct way around for the track.
When mounting the Milo onto the track when using Ramp Ups, it is
safer to remove the first section of rack from the Rail first. If the
rack is left projecting beyond the end of the rail, it will hit the Track
motor and will damage it.
Important
If a complete Milo with a Long Arm or a Titan arm is to be mounted
onto the rail with ramp ups, the ramp ups will need extra support,
(part of the Titan Kit) and it is
essential that the arm be facing
forward downslope to prevent the rig from tipping backwards when
going up or down the ramps.
Ramp-ups