MRM LFP, Быстрый старт

Страница: 8 / 92

LFP Quick Start Guide
4
Powering up and loading the head
There is no power switch on the LFP; the power is on whenever the
24-volt power supply is attached and live. Similarly, there is normally no
power switch on MRMC camera heads; the power is on whenever the
head has a 24-volt power supply that is live.
1. Attach the power cables to the head and the LFP after you have
attached all the other cables. Make sure the relevant indicators light
up; for example, the power indicator LEDs on all 24Volt power
supply bricks (
), and the power indicator LED on the head
( ).
Hint
It is recommended that you do not use the
POWER OUT
socket on
the LFP to power the head if you are using an Ethernet connection to
the head. If you do so then powering up the LFP will simultaneously
power up the head, and in this instance powering up two Ethernet
devices at the same time on the same network can cause
communication problems between them.
Hint
If you are using an Ethernet connection between the controller
and the head it is recommended that you power up the head
first and the controller last, as powering up two devices
simultaneously on the same network can cause communication
problems.
If you are using a Serial connection to the head you must power
up the controller first and the head last.