MRM LFP, Быстрый старт

Страница: 78 / 92

LFP Quick Start Guide
74
means to trigger the camera’s auto-focus. The controller generates a bloop
light trigger pulse through the above connectors at the start of move
playback.
The bloop trigger pulse is 40ms long, and the camera trigger pulse and
bloop trigger pulse are sent at the same time; there is no delay. If the
camera reaction is too slow and the recording misses the bloop then you
can start the camera in advance manually and the bloop will trigger as
usual when the move starts.
Camera sync in
For information on which pins you can use to input the camera sync
signal into the controller, see page 22.
Data In connector
The Data In (DataLink In) connector is used to connect the LFP to an
RT-12 or RT-14 interface box when the LFP is booted up in Flair mode
and used only as a slave mimic device. For usage see page 71. Bit rate
10Mbps.
1. Watchdog–
2. In–
3. Out–
4. N/C
5. N/C
6. W
7. In+
8. Out+
9. N/C
9
5
1
6