MRC DRS4000, Руководство пользователя и техническое руководство

Страница: 75 / 88

Installation 4-13 DRS4000 Receiver User and Technical Manual
multiplexer. The maximum bit rate is adjustable up to 40 Mbps.
ASI OUT These connectors are 75 ohm, female, BNC
connectors that provide a diversity ASI output or a multiplexed
ASI output according to the mode set for the packet.
SDI OUT This connector is a 75 ohm, female, BNC connector
that outputs a digital video stream.
4.16 Initial Power Up
When the wiring and installations are completed, it is time to
power up the receiver system. As good practice, you should
make a final check of all wiring and hardware installations before
power is applied.
4.16.1 Checks Before Power Up
CAUTION Be sure the power being supplied matches the
power required by the equipment.
• Double check to verify all cables are connected to the
correct connectors.
• Make sure all connectors are fully mated, properly mated,
and are secured.
4.16.2 Initial Power Up
Now you are ready to apply power.
1. Power up the receiver system per “Powering the
Receiver” on page 2-5 .
Note The following steps must be performed by your
System Administrator.
2. Perform “Select IP and MAC Addresses” on page 2-15
to set up the IP addresses, etc.
3. If everything appears to be normal, test the
performance of your receiver system by setting up a
link and transmitting and receiving video and audio.
If you have any problems, refer to “Troubleshooting”
on page 3-1 .
4.17 Product Modifications
CAUTION If you modify a product without authorization
from MRC, you will void the warranty.
The product you purchased has been carefully designed and
tested and is warranted to meet specifications when connected
and operated as described in this manual.