MRC DRS4000, Руководство пользователя и техническое руководство

Страница: 17 / 88

Routine Operation 2-1 DRS4000 Receiver User and Technical Manual
Routine Operation
2.1 Chapter Overview
This chapter provides basic information that will enable you to
operate your DRS4000 Receiver.
Here are the topics covered:
Topic Page
Controls, Indicators, and Connectors 2-2
Front Panel Controls, Indicators, and
Connectors 2-4
Rear Panel Connectors 2-4
PACKET Connectors 2-5
Preparing for Operation 2-5
Installation 2-5
Powering the Receiver 2-5
Control Menu Operations 2-9
Using the Video Monitor 2-8
Keypad Operation 2-8
Routine Operations 2-9
Control Menu Operations 2-9
Change Channel 2-10
Change Frequency 2-10
Monitor RF Band 2-11
Change Modulation Mode 2-11
Change Video Decoder 2-12
Select Audio Output 2-12
Select Polarity 2-13
Select a New Preset 2-13
Setup Menu Operations 2-13
Review Hardware Configurations 2-14
Select RF Switch Matrix 2-14
Select IP and MAC Addresses 2-15
Change Use Service Information Mode 2-16
Review or Change PIDs 2-16
Set Frame Sync 2-18
Set Frame Sync Offset 2-18
Set Video Color Bar Output 2-19
Adjust Analog Audio Level 2-19
Adjust Digital Audio Level 2-20
Adjust SDI Embedded Audio Level 2-20
Set RS-232 Data Output 2-21
Set Spectrum Overlay 2-21
Select Audio Output 2-22
Select Demodulator Switch 2-22
Enter Service Name 2-23
Set Video Fail Mode 2-23
Set NTSC Pedestal 2-24
Select Encryption Mode 2-24
Select/Edit Site Management Name 2-26
Activate Site Management 2-26
Select Packet Switch Configuration Unit
Mode 2-27
Select Packet Switch Configuration ASI Mode 2-27
Select Packet Switch Configuration Default
Service Name 2-28