4. MEASURING PROCEDURE
4-1 Conductivity measurement
(1) Push the "Power Off/On Button"(3-2, Fig. 1) to power the
instrument.
(2) The instrument will default to 2% per Temperature
℃
Compensation factor. The meter has built-in Automatic
Temperature Compensation adjustable between 0 to 5%
per .
℃
In order to change the default value carry out the
following procedures :
a. Push the "Temp. Compensation Button"(3-10, Fig.1)
,the display will show
2.0 %
P
℃
b. Push the "Factor Adjust Button"(3-8, Fig. 1) to select
the desired compensation factor. The value will
increment in steps of 0.1 % per .
℃
c. Once the desired value is reached, push the "Temp.
Compensation Button"(3-10, Fig. 1) to set the new
value.
(3) Select the applicable range, using the "Range Select
Button"(3-9, Fig. 1).
* If the display shows "- - - -", it indicates an overload
condition, select the next higher range.
* If the display shows "_ _ _ _", it indicates an
out-of-range condition, select the next lower range.
5