Mr12volt P600 Series
For Audi
MMI 2G Basic/High
Model No: P600-LP1605AU
1. Introduction
The MR12VOLT P600 Series lets you connect Bluetooth
devices, USB flash drive, Micro SD card and AUX In devices
to your original car radio, providing Hi-Fi quality music
playback and simple menu based control through your
radio. The Bluetooth also provides you A2DP music
streaming and hands free functions which integrates to
your original steering wheel buttons.
Package content :
•
Main Module
•
3way Optical cable (M.O.S.T.)
•
Power Lead
•
3.5mm Jack to Jack cable
•
Microphone (270cm)
2. Programming & Qualifier
⚫
No Coding required for Audi MMI 2G, it works With
and Without 6 CD changer.
⚫
Phone book list does not work on MMI 2G Basic
(Monochrome display)
Main Module Overview
3. Installation
⚫
Important note:
When you connect the power
harness please make sure that you supply Mr12Volt
device with +12V non-switched constant power.
⚫
Please make sure that
during installation, you don’t
disconnect other devices of the optical ring, (for
example the amplifier of the car).
For MMI 2G High
Factory 6 CD changer can be installed and used in
conjunction with P600
⚫
3 way split F.O. cable is used to install and bridge
behind any of the Audi MMI devices through the
M.O.S.T fiber (Remove any of them out, preferably
the 6 CD changer which is easier for access and
removal, install Mr12volt P600 behind and make a
bridge connection using the split F.O. cable in the
package) see fig.02
Fig. 02 Split F.O. cable
⚫
Getting the power source : Connect Red wire lead to
12+
Constant
power from car wiring harness and
Black wire lead to ground.
⚫
At your own choice you can wire up microphone at
your desire position, it is recommended to wire
through
“A” Pillar and to the top of windscreen.
For MMI 2G Basic
The Factory 6 CD changer must be disconnected
from the M.O.S.T system.
⚫
Mr12volt P600 emulates CD changer function,
installation is simple and direct. Simply remove the
original 6CD Changer connector and connect directly
to Mr12volt P600 device instead. The split F.O. cable
is not used in this case.
⚫
If your mmi is without the Cd changer, 3 Way split
F.O. cable is used to install and bridge behind any of
the Audi MMI devices within the M.O.S.T ring
(Remove any of them out, install P600 behind and
