MR tapcon 240, Руководство по эксплуатации

Страница: 43 / 174

6 Commissioning
Maschinenfabrik Reinhausen 2014 43 222/08 EN TAPCON® 240
Date
To set the date, proceed as follows:
1. > Configuration > Continue > Memory > Press
until the desired display appears.
ð Date
2. Press to highlight a digit.
ð The desired position is highlighted and the value can be changed.
3. Press to increase the value or to reduce it.
4. Press .
ð The date is set.
Setting further parameters
Set further parameters to commission the device. More detailed information
about each of the parameters can be found in the Functions and settings
[
► 54] chapter.
Setting transformer data
Set the transformer data and phase difference of the current transformer and
voltage transformer:
1.
Set primary transformer voltage [ ► 98].
2. Set secondary transformer voltage [ ► 99].
3. Set primary transformer current [ ► 99].
4. Select current-transformer connection [ ► 100].
5. Select transformer circuit [ ► 101].
Setting NORMset
If you want to commission voltage regulation quickly, you can activate
NORMset mode. If you want to set the parameters yourself, continue with
the sections below.
► Activate NORMset and set the relevant parameters [
► 63].
Setting control parameters
Set the following control parameters:
1.
Set desired value 1 [ ► 67].
2. Set the bandwidth [ ► 68].
3. Set delay time T1 [ ► 70].
6.2.3