MR ECOTAP VPD CONTROL PRO, Руководство по эксплуатации

Страница: 81 / 192

8 Operation
Maschinenfabrik Reinhausen GmbH 2018 81 5252433/02 EN ECOTAP
®
VPD
®
CONTROL PRO
8.5 Transformer data
The transformation ratios and measuring set-up for the voltage and current
transformers used in the system can be set with the following parameters.
The device uses this information to calculate the corresponding measured
values on the primary side of the current transformer (and therefore the
transformer) from the recorded measured values. These are then displayed.
Figure 60: Setting transformer data (example)
8.5.1 Setting the primary transformer voltage
With this parameter, you can set the primary voltage of the voltage trans-
former in kV.
To set the primary transformer voltage, proceed as follows:
1. Go to Settings > Parameters > Transformer data > Primary trans-
former voltage .
2. Enter the primary transformer voltage.
3. Press the Accept button to save the modified parameter.
8.5.2 Setting the secondary transformer voltage
With this parameter, you can set the secondary voltage of the voltage trans-
former in V.
To set the secondary transformer voltage, proceed as follows:
1. Go to Settings > Parameters > Transformer data > Secondary trans-
former voltage .
2. Enter the secondary transformer voltage.
3. Press the Accept button to save the modified parameter.