MR ECOTAP VPD 3 30D-24, Руководство по эксплуатации

Страница: 98 / 132

8 Control system protocol
Maschinenfabrik Reinhausen GmbH 2021 98 8209941/00 EN ECOTAP
®
VPD
®
III 30D-24 / MD&C
Address Name Coil status EXTERNAL CONTROL
R = read / W = write
CONTROL PRO Others
13 E6.3 Tap change command cannot be performed 1 = active R R
14 E7. Correct positioning not possible 1 = active R R
15 E7. Correct positioning not possible 1 = active R R
20 Blocking contact 0 = door open
1 = door closed R R
21 Relay OK 1 = active R R
22 Relay error 1 = active R R
23 E2.1 Highest or lowest operating position reached 1 = active R R
24 E2.2 Previous tap-change operation has not been
completed or fault motor-drive unit 1 = active R R
25 E2.3 Inrush interlock is active or automatic adjust-
ment required 1 = active R R
26 E2.4 Energy in the energy accumulator too low. 1 = active R R
27 E2.5 Signal for blocking activated (door interlock or
temperature blocking) 1 = active R R
28 Motor drive running 1 = active R R
29 Ready for tap-change operation 1 = active R R
30 Voltage failure 1 = active R R
Table 16: Discrete inputs
8.4.3 Input Register
Address Name Unit Decimal
places EXTERNAL CONTROL
R = read / W = write
CONTROL PRO Others
2 Capacitor health % 0 R R
5 Software version year - - R R
6 Software version month - - R R
7 Software version day - - R R
8 Motor pause before next tap-change operation seconds 1 R R
Table 17: Input register