MR ComTroll 115C, Руководство пользователя, Страница: 8 / 15

Page 8
User Manual for ComTroll 115C
LED Indications:
Rx/Tx: Flashing when the unit is sending or receiving.
Running: Flashing when the unit is powered and running OK.
Please note that both LED’s are used for other indications during special operations. See the
specific sections for explanations.
Switches and buttons
Reset Remote: Used for test, reset, status check and programming of the Fault indicators.
This button is connected in parallel with Terminal 2 in the input connector.
Reset Collector: Resets the ComTroll 115C collector unit. Active relay outputs will also be
reset. Reset Collector must take place after changing/setting the Address
Selector. Button is connected in parallel with terminal 4 on the input
connector.
2.5 Table for address setting
ADDRESS
Switch on
CmT115C
Grouping LineTroll 110Eur/Tur addresses
No of
indica
tors
1 2 3 4 5 6 7 8 9
0 NOT VALID
1 Point-to-
point mode
1 R1
2 2 R1 R2
3 3 R1 R2 R3
4 Group á 3
indicators
Point-to-
Multipoint
4 R1 R1 R1 R2
5 5 R1 R1 R1 R2 R2
6 6 R1 R1 R1 R2 R2 R2
7 7 R1 R1 R1 R2 R2 R2 R3
8 8 R1 R1 R1 R2 R2 R2 R3 R3
9 9 R1 R1 R1 R2 R2 R2 R3 R3 R3
A NOT VALID
B Group á 2
indicators
Point-to-
Multipoint
2 R1 R1
C
4 R1 R1 R2 R2
D 6 R1 R1 R2 R2 R3 R3
E NOT VALID
F NOT VALID